AmpliVox SW805A User Manual download pdf

MULTIMEDIA STEREO AMPLIFIER W/INTERNAL WIRELESS

PORTABLE PUBLIC ADDRESS AMPLIFIER

MODEL SW805A

SET UP:

INSTALL POWER SUPPLY

The Battery pack is standard. Optional Power Supplies may be substituted. Model S1460, International

AC Adapter (110/220V, 50/60Hz). Model S1452, 12 Volt DC adapter (automotive cigarette lighter plug-

in). Model S1465, NiCad battery Pack.

TO INSTALL OR REPLACE BATTERIES

Slip fingernail under battery door on back of amplifier and slide it out. Remove battery holder from

amplifier. Insert 10 new Alkaline “D” cell batteries, observing polarity, or replace with S1465 NiCad

battery pack. Carefully replace battery holder. Slide door back into place.

Do not mix battery types or attempt to recharge alkaline batteries - equipment damage, safety hazard or

fire could result.

TO OPERATE:

Insure the microphone is plugged into DYNAMIC microphone jack. Insure the speaker is plugged into

either SPEAKER jack. Turn amplifier on (large rocker switch located on the front of the amplifier). The

red light will go on, showing that power is available. Push switch on microphone to the on position.

Rotate VOLUME control knob to obtain desired loudness level throughout the coverage area.

ON-OFF

When power switch is in the ON position, the red light will be on.

DC IN

Connection for optional power adapter:

•

S1460 International AC Adapter/Recharger (110/220V, 50/60Hz)

•

S1452 12 Volt DC (automotive cigarette lighter) Adapter

AUX OUT

Connection for 12 to 15V DC accessory.

VOLUME

Rotate clockwise to increase amplification.

MICROPHONE INPUTS

There are three microphone inputs, which can be used simultaneously:

DYNAMIC - for standard dynamic cartridge microphones

CONDENSER - for electret or condenser microphones, which require phantom power

(supplied from the amplifier)

WIRELESS - accepts line-level output from wireless microphone receiver

1 2 3 4

Summary of Contents

Page 1

MULTIMEDIA STEREO AMPLIFIER W/INTERNAL WIRELESS PORTABLE PUBLIC ADDRESS AMPLIFIER MODEL SW805A SET UP: INSTALL POWER SUPPLY The Battery pack is sta

Page 2

LINE IN L+R (SEPARATE-COMBINED) Combines the separate left and right AUX LINE IN channels. This combined signal will be amplified and appear on both

Page 3

ANTENNA2. Power Indicator Light4. Mic Volume—controls all 3 micinputs5. Dynamic MicJack—for wired,hand-held mic7. Tone Control—for auxiliary input; co

Page 4 - WARNING:

No Sound?1. Make sure the amp’s power switch is turned on.The red light next to the power switch should be lit.2. Make sure the batteries are not dead

Comments to this Manuals

No comments

AmpliVox SW805A User Manual

Browse online or download User Manual for Musical Instrument Amplifier AmpliVox SW805A. AmpliVox SW805A User's Manual

Summary of Contents

Comments to this Manuals